350-080 무료 덤프문제 온라인 액세스

Refer to the exhibit.

The customer has a one-switch fabric, and is connecting another switch. From the Fibre Channel Analyzer output in the exhibit, identify who is the principal switch in this two-switch fabric?

• A.The EFP frame is not used to determine principal switch selection. Principal switch selection is decided earlier in the ISL link initialization process.
• B.The principle switch is the switch that sent the second EFP in the trace.
• C.The principle switch is the switch that sent the first EFP in the trace.
• D.The principle switch cannot be identified from the information given in the exhibit.

Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager? (Choose three.)

• A.The fabric interconnect is in the end-host mode, and all uplink ports have failed.
• B.The link for a network-facing host interface is missing.
• C.A transient error has caused the link to fail.
• D.The server port to which the adapter is pinned has failed.
• E.The fabric interconnect is in the switch mode, and all uplink ports have failed.

Which Ether type is used to identify FIP?

• A.0x8905
• B.0x8915
• C.0x8906
• D.0x8914

After configuring FabricPath, the following appears in the syslog:
%STP-2-L2GW_BACKBONE_BLOCK: L2 Gateway Backbone port inconsistency blocking port port-channel100 on VLAN0010.
What is the cause of this message?

• A.STP is misconfigured; root guard must be disabled.
• B.A superior BPDU is received on a Cisco FabricPath edge port.
• C.An inferior BPDU is received on a Cisco FabricPath edge port.
• D.STP must be disabled; message indicates that STP is enabled.

Refer to the exhibit.

Which three statements are true? (Choose three.)

• A.The Cisco UCS Manager is in end-host mode.
• B.Two separate physical SAN switches are upstream of Cisco UCS.
• C.There are 14 blades active in the system.
• D.Zoning is configured on Cisco UCS Manager.
• E.Zoning is configured on the upstream SAN switch
• F.Storage is attached directly to Cisco UCS.
• G.The Cisco UCS Manager is in switch mode.
• H.There are 7 blades active in the system.