350-050 무료 덤프문제 온라인 액세스

You are designing a wireless infrastructure for an enterprise customer in the busy international banking district of Tokyo. All the client adapters are fairly modern, so you have turned off 802.11b speeds to reduce the size of your cells. Which channels will you choose to make optimum use of the available spectrum?

• A.1, 6, 11, 14
• B.1, 5, 9
• C.1, 5, 9, 13
• D.1, 4, 7, 11, 14
• E.1, 6, 11

You are configuring a Cisco WLC in a hotel that provides wireless guest access to the Internet, using web authentication. Guest credentials are generated for individual rooms upon check-in. Users often complain about certificate security warnings when opening their browser. You need to fix this issue so that the clients stop getting this certificate warning every time they access the Web-Authentication page, but still protect the credentials during the authentication handshake of this guest setup. You cannot configure the user devices yourself. What is the best solution that meets these requirements?

• A.Remove the self-signed SSL certificate of the WLC or make sure that the clients know about the WLC CA that generated this self-signed certificate.
• B.Configure the WLAN with an EAP method that does not use PKI certificates, but still protects the credentials during the authentication handshake.
• C.Disable HTTPS on the WLC to avoid the certificate warning during the web authentication.
• D.Install a third-party SSL certificate on the WLC, issued by a known public CA.

Which statement about heat maps on Cisco WCS is true?

• A.They are based on real-time actual values because of fingerprinting.
• B.They are predictive but can be converted to real values by using the Refresh from network button.
• C.They are based on real-time actual values if Cisco Compatible Extensions is enabled on the APs.
• D.They are predictive and rely only on the accuracy of the information that is provided with the map.

Refer to the exhibit.

You have setup an autonomous AP and configured an SSID to serve clients. While troubleshooting a client that is not able to associate to the SSID, you enable some debugs. Given the debug output seen in the exhibit, what is most likely the cause of association failure?

• A.The SSID is secured with PSK and the shared secret is wrong.
• B.The SSID is configured with TKIP encryption and the client PC is using AES encryption.
• C.The RADIUS server is rejecting the dot1x authentication due to a message integrity check failure.
• D.The authenticating EAP method is PEAP and the username and password combination is incorrect.

Refer to the exhibit.

You want to use 3500e APs to setup an indoor mesh deployment. After you change the AP mode, the AP will not rejoin the Cisco WLC. Which debug command was run, according to the exhibit, and why is the AP not rejoining the Cisco WLC?

• A.debug capwap events enable was run, and the 3500e Ethernet MAC address is not in the local MAC filter list on the Cisco WLC.
• B.debug ap join was run, and you must disable VLAN transparent for 3500e indoor mesh deployments.
• C.debug mesh security was run, and the 3500e radio MAC address is not in the local MAC filter list on the Cisco WL
• D.debug capwap packet was run, and 3500e APs do not support indoor mesh.
• E.debug pm pki was run, and you must disable VLAN transparent for 3500e indoor mesh deployments.