350-001 무료 덤프문제 온라인 액세스

Apart from interdomain multicast routing, what else is MSDP used for?

• A.Anycast RP
• B.Announcing multicast sources to BGP speakers
• C.Intradomain multicast routing
• D.Source Specific Multicast and IGMPv2

Which of these statements about anycast RPs is correct?

• A.Anycast RPs cannot be used in conjunction with Auto-RPs.
• B.The anycast RPs must reside within the same IGP domain.
• C.After a failure of one of the anycast RPs, the PIM network will reconverge on the remaining anycast RP or RPs in roughly the same time that it takes unicast routing to reconverge.
• D.After a failure of one of the anycast RPs, the PIM network will reconverge on the remaining anycast RP or RPs in less than one second.

Why would a rogue host that is running a DHCP server on a campus LAN network present a security risk?

• A.A potential man-in-the-middle attack can be used against the clients.
• B.All multicast traffic can be sniffed by using the DHCP multicast capabilities.
• C.The CPU utilization of the first hop router can be overloaded by exploiting DHCP relay open ports.
• D.It may allocate IP addresses from an unknown subnet to the users.

Refer to the exhibit.

There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B.
What would be two suggestions to load-balance the traffic across both WAN links? Choose two.

• A.Replace HSRP with GLBP.
• B.Replace HSRP with VRRP.
• C.Make R3 and R8 have lower HSRP priority than R1 and R7.
• D.Make HSRP track interfaces between the edge and core routers.
• E.Add crossed intrasite links: R1-R4, R2-R3, R5-R8, and R6-R7.

After applying a new ACL on a device, its CPU utilization rose significantly and many messages starting with "%SEC-6-IPACCESSLOG" appeared on the Syslog server. What can be done to resolve this situation?

• A.Remove the log keyword from each ACL entry.
• B.Increase memory allocation for ACLs.
• C.Remove all entries from the ACL and use a single permit ip any any statement.
• D.Reboot the device after the ACL has been applied.