300-615 무료 덤프문제 온라인 액세스

An engineer attempts to register Cisco UCS Manager to Cisco UCS Central, but the registration fails. The engineer can ping Cisco UCS Central from UCS Manager. Which two actions must the engineer attempt to resolve the problem? (Choose two.)

• A.Place Cisco UCS Manager on the same subnet as Cisco UCS Central.
• B.Allow port 443 between Cisco UCS Manager and Cisco UCS Central.
• C.Apply the UCS Central license to UCS Central.
• D.Synchronize the date and time to NTP for Cisco UCS Central and the Cisco UCS domains.
• E.Allow port 9443 between Cisco UCS Manager and Cisco UCS Central.

A Cisco ACI fabric consists of three tenants User 1 must have permission to manage only the PROD tenant.
These configurations have already been completed *The security domain IbNANI has been created.
*User1 has been created with the " write " privilege level
*User1 has access to all leaf nodes
The configuration was deployed, but User1 still has access to all the other tenants. Which action resolves the issue?

• A.Attach local user User1 to security domain all
• B.Associate security domain TENANT to tenant PROD
• C.Add local user User1 to the RBAC node rule
• D.Enable the restricted domain under security domain TFNANT

Refer to the exhibit. Two Cisco Nexus 9000 Series Switches fail to establish OSPF adjacency. Which configuration resolves the issue?

• A.N9K2(config)# interface loopback 0
  N9K2(config-if)# ip address 3.3.3.3/32
• B.N9K1(config)# interface loopback 0
  N9K1(config-if)# ip router ospf Telco area 0.0.0.0
• C.N9K2(config)# interface eth1/2
  N9K2(config-if)# ip address 172.18.1.200/24
• D.N9K1(config)# router ospf Telco
  N9K1(config-router)# router-id 3.3.3.3

An engineer enables the packet postcards feature on a Cisco Nexus 9000 Series Switch but receives the error message " Error: Cannot configure postcard when inband-telemetry is configured. " Which action resolves the issue?

• A.Disable the inband-telemetry feature
• B.Disable the software-telemetry feature
• C.Disable the hardware-telemetry feature
• D.Disable the telemetry feature

Refer to the exhibit.

A certificate is implemented on the security configuration on the Cisco ACI controller. A customer receives a
" Connection Not Secure " error in a browser every time the customer logs in to the Cisco APIC GUI. Which action resolves the issue?

• A.Configure a corporate certificate authority for the certificate.
• B.Include a private key with the certificate.
• C.Use a browser that supports keys of 2048 bits.
• D.Add a 1536-bit key to the APIC GUI.