300-610 무료 덤프문제 온라인 액세스

An engineer must connect a Cisco UCS B-Series based system to an existing large storage area network fabric. The deployment must support hardware-based load balancing, prevent Fibre Channel domain ID exhaustion, and enable all blade servers to be in the same VSAN.
Which set of actions meets the requirements?

• A.Connect the fabric interconnect to the E Ports on the SAN switch.
  Create a SAN port channel.
• B.Place all interfaces that face the fabric interconnects in the same VSAN.
  Disable zoning for the VSAN.
• C.Configure Ethernet end-host automatic load balancing on the fabric interconnect.
  Set NL port mode on the SAN switch.
• D.Enable Fibre Channel end-host mode on the fabric interconnect and NPIV mode on the SAN switch.
  Create an F Port channel that faces the fabric interconnect.

Refer to the exhibit. A Cisco engineer is planning a data migration job in heterogeneous SANs where the existing and new storage devices for the migration are already connected to the MDS switches. All paths from the SSM to the storage-connected switch are going through the Cisco fabric. The setup is with active/active arrays and multiple LUN sets. What is the best approach to copy the LUN sets to the new location?

• A.Enable synchronous replication for the new storage array
• B.Add all paths Fabric-A zones to Fabric-B zones
• C.Create two data migration jobs and add two storage ports in each job
• D.Grant access to all servers to the existing data sets

A company wants to use the Cisco hyperconverged system in two data centers. The company plans to implement five HX servers in each data center, and there is no connectivity between the data centers or between the data centers and the internet.
Which solution must the company implement in each data center?

• A.ROBO HX cluster
• B.edge HX cluster
• C.standard HX cluster
• D.stretched HX cluster

Which statement accurately describes the result of disabling restrictions on oversubscription ratios on Cisco MDS 9000 Series Fibre Channel switching modules?

• A.QoS can be configured.
• B.The bandwidth allocated to shared ports is proportionate to the configured speed of the ports.
• C.The bandwidth allocation of the shared ports is equal to the lowest configured bandwidth.
• D.A port-group can contain a single port only.

Refer to the exhibit. The data center DC1 uses VXLAN technology. The company asked a service provider to design another data center called DC2 and stretch EVPN information between the data centers based on the same technology. The fabric requires:
- endpoint information propagated end-to-end across both data centers
- misconfiguration replicated from DC1 to DC2
Which actions must the design include in DC2 to meet these criteria?

• A.- Set BGP AS to 65501
  - Configure EIGRP as an underlay IGP
• B.- Set BGP AS to 65500
  - Configure IGRP as an underlay IGP
• C.- Set BGP AS to 65500
  - Configure RIP as an underlay IGP
• D.- Set BGP AS to 65501
  - Configure RIP as an underlay IGP