300-165 무료 덤프문제 온라인 액세스

If you are using NAT in your data center, which load balancing would you be likely to use within your GLBP configuration?

• A.none
• B.weighted
• C.host dependent
• D.round-robin

Which two options should you consider when you configure a SAN zone set? (Choose two.)

• A.A SAN zone set must be activated manually on all of the fabric nodes.
• B.A SAN zone set consists of one or more SAN zones.
• C.Only the SAN zone set can be activated simultaneously.
• D.VSANs can be activated by using enhanced zoning.
• E.One SAN zone can be the member of only one zone set.

Refer to the exhibit.

You configure two switches named NEXUS1 and NEXUS2. Which two results of implementing the configuration are true? (Choose two.)

• A.NEXUS1 is the spanning-tree root for VLAN 100.
• B.NEXUS1 is the spanning-tree root for VLAN 998.
• C.NEXUS2 is the spanning-tree root for VLAN 100.
• D.Both switches are the spanning-tree root for VLAN 100.
• E.Both switches are the spanning-tree root for VLAN 998.

Refer to the exhibit.

Which statements about the configured LACP parameters is true?

• A.NEXUS1 uses the default LACP system priority
• B.NEXUS uses the default LACL system priority.
• C.Ports 3 and 4 on NEXUS1 run LACP
• D.NEXUS1 load balances traffic by using the source and destination MAC addresses.

Refer to the exhibit,

Which description of the output is true?

• A.The table output apply to the default VRF
• B.The default map-cache limit is used.
• C.PETR is disable
• D.The switch acts as an IPv4 LISP ETR