300-135 무료 덤프문제 온라인 액세스

You work as Network Engineer for RADO network Ltd company. You colleague has setup POC simulating customer network to study about the behavior of BGP protocol when routes are exchanged between two different autonomous systems.
Review the topology. You need to identify and fix IBGP and EBGP issues on R1 router.
Topology Details:
AS64520
* R1, R2 and R3 are three routers on AS 64520 and OSPF is IGP routing protocol configured between them.
* IBGP configured between R1, R2, and R3 routers using peer group.
* Loopback0 address is used for IBGP peering, Loopback0 address configured on R1, R2 and R3 are advertised into BGP domain on AS64525.
AS64525
* RA and RB are two routers on AS64525 and EIGRP is IGP routing protocol configured between them.
* Loopback0 address is used for IBGP peering, Loopback0 address configured on RA and RB advertised into BGP domain on AS64525.
* R1 and RRA from EBGP neighbor relationship using physical interface address.
*R2 and RB from EBGP neighbor relationship using physical interface address.
Simulation requirements:
*Identify and fix EBGP neighbor relationship between R1 and R1 routers.
*Identify and fix IBGP neighbor relationship issue between R1 and R2, R1 and R3.
*You are allowed to remove any misconfiguration or incorrect configuration to only fix the issue and other initial configuration that not impacting the issues should not be changed.
* The Final BGP table, after fixing two issues on R1 router should display as shown below

Refer to the exhibit.

which action resolves the issue?

• A.configure a key on the Tunnel0 interface
• B.Enable GRE keepalive on the Tunnel0 interface
• C.add a static route for the Tunnel0 destination IP address
• D.Use a loopback interface for the Tunnel0 source IP address

The implementations group has been using the test bed to do a 'proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, and FHRP services, a trouble ticket has been operated indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to Isolated the cause of this fault and answer the following questions.
On which device is the fault condition located?

• A.R3
• B.DSW1
• C.R2
• D.ASW1
• E.DSW2
• F.ASW2
• G.R4
• H.R1

When is uRPF desired to be applied using loose-mode for security reasons?

• A.symetric mode
• B.PIMv2
• C.Asymmetric

Refer to the exhibit. BR-PC1 (192.168.100.10) cannot reach the Internet. Access to the internet is routed through the HQ site and all NAT configurations have been applied and verified. The user on BR-PC1 has run a traceroute. Which step is next to diagnose the issue?

• A.Check the MTU between BR-Rtr1 and HQ-Rtr1.
• B.Run a traceroute to the WAN IP address of HQ-Rtr1.
• C.Ping the LAN IP address of the HQ-Firewall.
• D.Make sure the HQ-Rtr1 and HQ-Firewall are within the same VLAN.