200-355 무료 덤프문제 온라인 액세스

When using multiple SSIDs on a lightweight AP, how does the traffic of each SSID reach the
802.3 network?

• A.Configure 802.1q trunking on the Ethernet switch port that is connected to the AP
• B.Configure the SSIDs on the WLC and it will regulate the traffic based on traffic type
• C.Provide routing between them at the core so that the SSIDs can reach the internet
• D.Configure ACLs at the switch port that will allow all desired SSIDs to pass traffic

Which two are considered as characteristics of the original 802.11 protocol? (Choose two )

• A.Defined DSSS and FHSS as possible methods for modulation.
• B.The most common deployment is 6 non-overlapping channels that are 20 MHz wide.
• C.Defined FIHSS and OFHM as possible methods for modulation
• D.The most common deployment is three non-overlapping channels that are 20 MHz wide
• E.Designed to operate in the 5 GHz ISM frequency spectrum.

Which two options are considered to be non-real-time applications? (Choose two.)

• A.email
• B.Collaboration
• C.video
• D.Citrix remote desktop
• E.social media

Refer to the exhibit.

An engineer wants to setup a mobility anchor for the Guest WLAN, but does not see the Anchor IP address listed in the drop-down. What is the most likely cause of this problem?

• A.The mobility anchor must also be included in the mobility group of the WLC
• B.The mobility anchor is currently unreachable
• C.The mobility anchor is attached to another WLAN
• D.Layer 3 Security must be configured for Web Policy Authentication

A company wants to implement wireless in all 20 remote office locations and wants centralized management of these remote sites. What application would meet the requirements?

• A.Cisco point to multi point wireless bridging
• B.Control and provisioning of wireless access points
• C.Split MAC architecture utilizing LWAPP and WLC
• D.Cisco autonomous access points in flexconnect mode