200-105 무료 덤프문제 온라인 액세스

Which statement about access lists that are applied to an interface is true?

• A.You can place as many access lists as you want on any interface.
• B.You can apply multiple access lists with the same protocol or in different directions.
• C.You can apply only one access list on any interface.
• D.You can configure one access list, per direction, per Layer 3 protocol.

Scenario:
You work as Junior Network Engineer for RADO Network Ltd company. Your colleague has set up a Layer 2 network for testing purpose in one of your client locations. You must verify the configuration and fix if any issues identified as per customer requirements.
Topology Details
- Three switches (SVV1. SW2, and SW3) are connected using Ethernet link as shown in the topology diagram.
- Server1 and PC1 are connected to SW1 and are assigned to VLAN 500 and VLAN 600 respectively.
- Server2 and PC2 are connected to SW2 and are assigned to VLAN 500 and VLAN 600 respectively.
- PC3 is connected to SW3 and assigned to VLAN 600.
Customer requirements
- Verify if switch ports are assigned in correct VLANs as per topology
diagram Identify and fix any misconfigurations found in three switches.
- Verify if trunk links are operational between switches and the IEEE
802.1 q trunk encapsulation method is used Identrfy and fix if any
misconfigurations are found in the trunk configuration
- You must make sure the ports connected between switches are set as
trunk ports.
Special Note: To gain the maximum number you must make sure that VLANs are assigned to switch ports as per customer requirements and make sure the trunk links are operational between switches Do not change VLAN names and VLAN number that are already configured in the switches

If you configure syslog messages without specifying the logging trap level, which log messages will the router send?

• A.error conditions only
• B.normal but significant conditions only
• C.warning and error conditions only
• D.all levels except debugging
• E.informational messages only

Refer to the exhibit. A network engineer is troubleshooting an Internet connectivity problem on the computer. What is causing the problem?

• A.wrong default gateway
• B.incorrect IP address
• C.wrong DNS server
• D.incorrect subnet mask

What can cause two OSPF neighbors to be stuck in the EXSTART state?

• A.There is a low bandwidth connection between neighbors.
• B.There is only layer one connectivity between neighbors.
• C.The OSPF interfaces are in a passive state.
• D.The neighbors have different MTU settings.