156-115.77 무료 덤프문제 온라인 액세스

Which information CANNOT be displayed by issuing the command cat /proc/cpuinfo?

• A.CPU family
• B.vendor_id
• C.fpu
• D.NFS_Unstable

Which flag in the fw monitor command is used to print the position of the kernel chain?

• A.-k
• B.-all
• C.-c
• D.-p

A firewall has 8 CPU cores and the correct license. CoreXL is enabled. How could you set kernel instance #3 to run on processing core #5?

• A.fw ctl affinity -s -k 3 5
• B.This is not possible CoreXL is best left to manage the Kernel to CPU core mappings. It is only when a daemon is bound to a dedicated core that CoreXL will ignore that CPU core when mapping Kernel instances to CPU cores.
• C.Run fwaffinity_apply -t 3 -k 5 and then check that the settings have taken affect with the command fw ctl multik stat.
• D.Edit the file fwaffinity.conf and add the line "k3 cpuid 5"

From the output of the following cphaprob -i list, what is the most likely cause of the clustering issue?
Cluster B> cphaprob -i list Built-in Devices: Device Name: Interface Active Check Current state: OK Device Name: HA Initialization Current state: OK Device Name: Recovery Delay Current state: OK Registered Devices: Device Name: Synchronization Registration number: 0 Timeout: none Current state: OK Time
since last report: 3651.5 sec
Device Name: Filter Registration number: 1 Timeout: none Current state: problem Time since last report: 139 sec Device Name: routed Registration number: 2 Timeout: none Current state: OK Time since last
report: 3651.9 sec
Device Name: cphad Registration number: 3 Timeout: none Current state: OK Time since last report: 3696.5 sec Device Name: fwd Registration number: 4 Timeout: none Current state: OK Time since last report:
3696.5 sec

• A.There is a sync network issue between Cluster A and Cluster B
• B.Cluster B and Cluster A have different versions of policy installed.
• C.There is an interface down on Cluster A
• D.The routing table on Cluster B is different from Cluster A

You are troubleshooting your VPN and are reviewing the output of your command fw monitor, shown below. What can you determine from the following output?

Checkpoint 156-115.77 Exam

• A.The fw monitor command cannot display the relevant information since it is encrypted traffic
• B.There is no issue, since the traffic is being seen at all points in the inspection kernel
• C.Traffic is not being encrypted
• D.NAT is not being applied to the IP address 10.10.10.86