CWDP-302 무료 덤프문제 온라인 액세스

A wireless engineer from your company performed a site survey in an office building where a wireless network extension was needed. He reports that while performing a Layer 1 sweep near a meeting room full of people, he detected RF activity with a very low duty cycle. He is unsure how to interpret what he recorded to determine its impact on a future Wi-Fi network.
What is true about this RF environment and its potential impact on the WLAN?

• A.The signal affects the entire spectrum and will render the wireless network unusable. It must be located and removed.
• B.The signal is alternating between peaks (high interference level) and valleys (low interference level).
  The network channel design must be built to avoid the affected peak frequencies.
• C.The signal is typical of a high radio card background noise. It shows that the card used for the Layer 1 sweep should be replaced and the Layer 1 sweep re-done.
• D.The signal has a low duty cycle and should not be of major impact on the wireless network.

You must specify security requirements for a WLAN. Which one of the following solutions would best provide for real-time monitoring of the WLAN?

• A.AP spectrum analyzer using a single AP with portable PoE battery support.
• B.Laptop-based protocol analyzer with multiple 802.11m adapters.
• C.A Wireless Intrusion Prevention System.
• D.AP protocol analyzer using a single AP with portable PoE battery support.
• E.Laptop-based spectrum analyzer with support for 2.4 GHz and 5 GHz.

Given: In a site survey deliverable report, you are expected to explain the spectrum measurements taken at the customer's site. What portion of a spectrum analyzer view can be used to determine if a given channel is too active for use as the active channel for a new AP?

• A.Frame decode
• B.Device list
• C.Duty cycle
• D.Real time FFT

iPerf is a tool used in site surveys and validation surveys for what purpose?

• A.Throughput testing
• B.RSSI tracking
• C.Signal strength mapping
• D.Data rate mapping
• E.CCI detection

When testing the signal strength and capacity in a site survey, which client type is generally best to use?

• A.a 3x3:3 laptop
• B.the least capable client type that will be used on the network.
• C.the most capable client type that will be used on the network.
• D.a single stream tablet