CAT-060 무료 덤프문제 온라인 액세스

You are customizing a subview. What is the purpose of the following line of XML code? <fieldsubview idref= "device-geninfo-subview-config?>

• A.Makes the fields in the configuration file editable
• B.References the default configuration file you are extending
• C.References the default configuration file you are overriding
• D.Implements input verifiers

In your distributed SpectroSERVER environment, you want to achieve cross-landscape fault isolation in a distributed SpectroSERVER without having duplicate alarms. Which feature enables you to achieve this?

• A.Proxy models
• B.SystemEDGE agents
• C.Alarm Notifications
• D.Install tickets

By default, if an alarm exists on a given model as a result of an event, CA Spectrum does not generate another alarm if the same event occurs again on the model. If you need to change this behavior, you can use:

• A.alarm counter rules
• B.alarm discriminators
• C.custom alarm events
• D.alarm attribute descriptors.

Use an Event Rate rule when you want:

• A.Notification of a series of events occurring in a specific sequence.
• B.No alarms for subsequent events of that event type.
• C.Notification of the absence of an expected second event after an initial event.
• D.Notification that there is a problem when a stream of the same events occurs at a set rate within a specified time frame.

Which step do you always need to perform when you create a custom privilege?

• A.Restart the CA Spectrum Tomcat service
• B.Open the Attribute Editor
• C.Restart the OneClick Console
• D.Open the Users List in the Contents pane