6103 무료 덤프문제 온라인 액세스

Which statement about the local router MAC addresses on RSMLT aggregation switches (cluster) is true?

• A.On a RSMLT aggregation switch pair, local router MAC addresses are exchanged, and only used in case of switch failure.
• B.On a RSMLT aggregation switch pair, the virtual MAC address is exchanged, and used for data forwarding.
• C.On a RSMLT aggregation switch pair, local router MAC addresses are exchanged, and always used for data forwarding.
• D.RSMLT aggregation switches are not exchanging local router MAC addresses, but are using the IP destination address to forward traffic.

Refer to the exhibit.

Simple Loop Prevention Protocol (SLPP) provides active protection against Layer 2 network loops on a per-VLAN basis. For the SLPP Tx process, the network administrator decides on which VLANs to enable SLPP. The hello packets are then replicated out all ports that are members of the SLPP-enabled VLAN.
Given the following information shown in the exhibit:
A = InterSwitch Trunk (IST)
B = Split MultiLink Trunk (SMLT)
# 1 VSP 9000
# 2 VSP 9000
# 3 ERS 4500
When setting up the SLPP Rx process, which configuration role is setup on VSP #1?

• A.The VSP #1 Rx process is enabled on all SMLT VLANs to monitor for the ERS #3 SLPP packets.
• B.The VSP # 1 Rx process is enabled on all SMLT VLANs to monitor for the VSP # 2 SLPP packets.
• C.The VSP # 1 RX process is enabled on port 3/1 to monitor VSP # 1 and VSP #2 SLPP packets.
• D.The VSP #1 Rx process is enabled on port 3/1 and the IST ports to monitor for the VSP #2 SLPP packets.

Within the context of virtual routing, which statement about the term VRF Lite is true?

• A.VRF will not calculate OSPF routes.
• B.The VRF router does not advertise,
• C.Device does not use MPLS for VRF.
• D.Device does not support BGP4.

Given the following command:
VSP-9012:1S show khi performance
Which Key Health Indicator is only valid for the CP modules?

• A.error-count
• B.buffer-pool
• C.CPU
• D.memory
• E.process

A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Virtual Services Platform (VSP) 9000 core. The technician needs to configure VRF on the VSP 9000.
Which statement represents the proper order for configuring a new VRF?

• A.Create a VRF, create a new VLAN, move the VLAN to the new VRF, and add an IP address.
• B.Create a VRF, create a new VLAN, add an IP address, and move the VLAN to the new VRF.
• C.Create a VRF, add an IP address, create a new VLAN, and move the VLAN to the new VRF.
• D.Create a new VLAN, add an IP address, create a VRF, and move the VLAN to the new VRF.