6101.1 무료 덤프문제 온라인 액세스

A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 lo a core pair of ERS 8600 switches.
Which statement about the correct uplink configuration is true?

• A.Enable Spanning Tree Protocol for the MLT when using it with SMLT in the core of the network.
• B.Disable auto negotiation and replace it with VLACP to identify single fiber fault failure
• C.Use unique MLT IDS for each stack of edge ERS 5500 switches
• D.Distribute uplinks across different ERS 5500 switches in the stack.

Click on the exhibit button After checking the VLAN configuration using the show vlan info basic and the show vlan info port commands, there are no ACTIVE MEMBER ports for VLM4-50.

What is causing this problem?

• A.AppleTalk Protocol VLANs do not have ACTIVE MEMBERS
• B.The default setting for this type of VLAN is potential and no AppleTalk traffic has entered any of these ports
• C.The ports have not been configured as active for this VLAN
• D.There are no devices connected to these ports.

What is the front panel port configuration for the Ethernet Routing Switch (ERS) 2550TPWR?

• A.50 10/100BaseT ports (PoE on 25 ports) two combo 10/100/1000BaseT or SFP port
• B.48 10/100 BaseT ports (PoE on 48 ports) Two combo 10/100/1000BaseT or SFP port
• C.48 10/100BaseT ports (PoE on 24 ports) two combo 10/100/1000BaseT or SFP port
• D.50 10/100BaseT ports (PoE on 50 ports) two combo 10/100/1000BaseT or SFP port

Winch CU command is used to validate that synchronization for High Availability mode is correct?

• A.show ha-all
• B.show ha-state
• C.show ha
• D.show ha-sync

A customer has purchased some Ethernet Routing Switch (ERS) 5600 switches must integrate two ERS 5600 units into existing stack of ERS 5500 switches.
What is the procedure for the integration of the new ERS 5600?

• A.Remove the AC from the stack, integrate the two ERS 5600 units into the existing 5600 set to "base unit" and one ERS 5600 set to "non base unit" set the existing ERS 5500 base unit to "non base unit" apply power to stack.
• B.with power applied to the slack, change the existing ERS 5500 base unit to "Non Base Unit" in mixed stack operation Integrate the two new ERS 5600 to the stack with them set as "Base Unit" in mixed stack operation Reboot the stack.
• C.With power applied to the stack, integrate one ERS into the stack as non base unit in mixed stack operational mode. After the two ERS 5600 units have obtained their configuration from the ERS 5500 base unit, change the ERS 5500 to "non base unit" and set one ERS 5600 to "base unit". Reboot the switch stack.
• D.With power applied to the stack, integrate one ERS into the stack as non base unit in mixed stack operational mode. Change the existing ERS 5500 base unit to "non base unit" and set the new 5600 to "base unit". Reboot the stack integrate the second ERS 5600 in mixed stack operational mode.