6101-1 무료 덤프문제 온라인 액세스

In Ethernet Routing Switch (ERS) 5600 switch was added into the existing ERS 5500 stack, but ft did not form a proper stack.
Which statement describes the problem?

• A.The ERS 5600 was set as the Base Unit.
• B.The ERS 5500 was set as the Base Unit.
• C.The mode parameter on the ERS 5600 switch was set to Mixed Mode.
• D.The stack was reset for a change in Base Unit to take effect.

What is the maximum number of Gigabit Ethernet ports on a single Ethernet Routing Switch (ERS) 8300 Input/Output module?

• A.48
• B.16
• C.24
• D.50

In a newly installed network the port LED on an Ethernet Routing Switch (ERS) 5500 is amber, not green. What does this mean?

• A.The port is set to operate at 100 Mbps.
• B.The port is set to operate at 10 Mbps.
• C.It indicates that there is a transmit fault.
• D.It indicates that the port is administratively disabled.

A technician is adding the Virtual Link Aggregation Control Protocol (VLACP) configuration ID a Converged Campus Solution where all Ethernet Routing switches (ERSs) are directly connected without intermediary WAN transport devices
What are two key configuration tasks? (Choose two)

• A.For the SMLT links, configure the long timeout value
• B.For the 1ST links, configure the long timeout value
• C.Configure all links to use a unique reserved multicast MAC address for VLACP messages
• D.configure all links to use the default multicast MAC address for VLACP messages

An engineer needs to assign an IP address of 172 25 10.31 for out of band management of an Ethernet Routing switch (ERS) 8600 switch a subnet mask of 255.255.255.192.
Which command line interface (CLI) command should the engineer use?

• A.ERS8600:5# config bootconfig net mgmt ip 172.25.10.36/26
• B.ERS8600:5# config bootconfig net mgmt ip 172.25.10.36/27
• C.ERS8800:5 # config bootconfig set ip 172.25.10 36/27
• D.ERS8600:5# config bootconfig set ip 172.26.10 36/26