A. Connect to the cloned VM and copy the directory to the source VM

B. Copy the directory from the snapshot disk to the original VM disk

C. Launch the Nutanix SSR utility on the VM

D. Select and mount the snapshot that contains the deleted directory

E. Create a clone of the VM from a previous snapshot and replace the original VM

A. Storage vMotion

B. Live Migration

C. Nutanix Move

D. Cross-Hypervisor DR

A. Do not include the 1 GbE interlaces in the same bond as the 10 GbE interlaces. Also, to avoid loops, do not add the 1 GbE interlaces to bridge brO, either individually or in a second bond. Use them on other bridges.

B. If you want to use the 1 GbE interfaces for guest VM connectivity, follow the hypervisor manulacturer's switch '- port and networking configuration guidelines.

C. If you want to use the 10 GbE interfaces for guest VM traffic, make sure that the guest VMs do not use the VLAN over which the Controller VM and hypervisor communicate.

A. Restart on a best-effort basis if resources are available

B. Perform a live migration to other hosts in the AHV cluster

C. Restart on other hosts in the AHV cluster

D. Perform a live migration on a best-effort basis if resources are available

A. One node hosts two VMs while the node being upgraded is in maintenance mode.

B. One VM out of the four powers down when the node hosting it reboots.

C. The AHV pre-upgrade checks fail until the administrator disables the anti-affinity policy.

D. The AHV pre-upgrade checks fail until the four VMs are powered off.