A. IGP routing is not passable

B. iBGP-Multi-hop is not configured

C. BGP protocol version inconsistencies

D. Authentication is unsuccessful

A. FALSE ?:B
499The series description for configuring static lSPs in MPLS networks is correct?

B. TRUE

C. When an LSR is a Transit LSR, you need to configure both In Label and Out label, both in the range of
16-1023

D. When an LSR is Ingress LSR, only configure Out Label, which ranges from 16-1048575

E. When an LSR is TransitLSR, you need to configure both ln Label and Out Label, both of which are
161023 The Out Label ranges from 16 to 1048575

F. When an LSR is An Egyptian LSR, only in Label needs to be configured, ranging from 16-1023

A. There is a firewall in the remote destination network, and the destination address can be reached without releasing ICMP traffic

B. Router HW does not have a legitimate router to reach the destination address

C. Ping is successful, but congestion occurs on the path to the destination address

D. The next hop router for router HW did not reach the destination address

E. ICMP packets, but the destination device fails to reply

A. All routers running the OSPF protocol listen to 224005

B. All hosts and routers in the network segment listen on 224001

C. All routers listen on 224002

D. All routers running the PIM protocol listen on 22400100

A. After you configure the Aggregate ipv4-address mask, only aggregate routes are published, not detail routes.

B. For IPv6 routing, BGP supports manual aggregation and automatic aggregation.

C. Routes in the BGP local route table can be manually aggregated.

D. BGP enables automatic aggregation by default.