GB0-381-ENU 문제 116
Execute the displaospf vlink command on the MSR router RTA, the router output is as follows:
OSPF Process 100 with Router ID 3.3.3.3
Virtual Links
Virtual-link Neighbor-ID -> 2.2.2.2, Neighbor-State: Full
Interface: 20.0.0.1 (GigabitEthernet0/1)
Cost: 1 State: P-2-P Tpe: Virtual
Transit Area: 0.0.0.1
Timers: Hello 10, Dead 40, Retransmit 5, Transmit Dela1
From the above output, you can judge _______.
OSPF Process 100 with Router ID 3.3.3.3
Virtual Links
Virtual-link Neighbor-ID -> 2.2.2.2, Neighbor-State: Full
Interface: 20.0.0.1 (GigabitEthernet0/1)
Cost: 1 State: P-2-P Tpe: Virtual
Transit Area: 0.0.0.1
Timers: Hello 10, Dead 40, Retransmit 5, Transmit Dela1
From the above output, you can judge _______.
GB0-381-ENU 문제 117
After executing the display ospt routing command on the MSR router RTA, the router output is as follows
Judging from the above output
Judging from the above output
GB0-381-ENU 문제 118
RIP 프로토콜은 라우터에서 활성화되고 프로세스 번호는 1이고 우선 순위는 10입니다. 동시에 OSPF 프로토콜이 활성화되고 프로세스 번호는 100이고 우선 순위는 100입니다. 두 프로세스가 네트워크 세그먼트 10.0.0.0/8의 경로를 동시에 학습하면 메트릭 값은 1( 홉 수) 및 100(비용 값), 다음 홉은 각각 1.0.0.1 및 1.0.0.2입니다.
라우터는 목적지 주소가 10.0.0.1인 패킷을 수신한 후 무엇을 해야 합니까?
라우터는 목적지 주소가 10.0.0.1인 패킷을 수신한 후 무엇을 해야 합니까?
GB0-381-ENU 문제 119
In the network shown in the figure, the default next hop of PTA is RTC, and the configuration of PBR is as follows:
policy-based-route pbr_a permit node 10
if-match acl 3000
appldefault output-interface serial 2/0
policy-based-route pbr_a dennode 20
According to the above configuration, what is wrong about the data stream matching Acl 3000 on the RTA?
policy-based-route pbr_a permit node 10
if-match acl 3000
appldefault output-interface serial 2/0
policy-based-route pbr_a dennode 20
According to the above configuration, what is wrong about the data stream matching Acl 3000 on the RTA?
GB0-381-ENU 문제 120
The router's IP routing table has an entry from 21.22.23.0/22. To import it into BGP, which of the following instructions should be used?