무료 온라인 액세스 H3C.GB0-381-ENU.v2022-12-19.q231 모의 시험 (Page 19)

GB0-381-ENU 문제 86

The picture shows the sending of Hello packets between RTA, RTB and RTC.

According to the above information, it can be judged that ______ between RTA and RTC, and ______ between RTC and RTB.

A. The adjacency has been established, the adjacency has been established

B. no adjacency established, no adjacency established

C. Adjacency established, no adjacency established

D. Adjacency not established, adjacency established

GB0-381-ENU 문제 87

In the topology shown in the figure, the correct IP addresses have been configured on RTA, RTB and RTC, and the network layer is reachable.

If OSPF neighbors need to be established between routers and routes are transmitted correctly, which of the following configurations are feasible?

A. RTA-Serial5/0] ospf dr-priorit100 RTA] ospf 1 router-id 1.1.1.1 RTA-ospf-1] peer 192.168.1.2 RTA-ospf-1] peer 192.168.1.3 RTA-ospf-1] area 0 RTA-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255 RTB] ospf 1 router-id 2.2.2.2 RTB-ospf-1] peer 192.168.1.1 RTB-ospf-1] area 0 RTB -ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255 RTC] ospf 1 router-id 3.3.3.3 RTC-ospf-1] peer 192.168.1.1 RTC-ospf-1] area 0 RTC-ospf- 1-area-0.0.0.0] network 192.168.1.0 0.0.0.255

B. RTA-Serial5/0] fr map ip 192.168.1.3 20 broadcast RTA-Serial5/0] fr map ip 192.168.1.2 50 broadcast RTA-Serial5/0] ospf network-tpe p2mp RTA] ospf 1 router-id 1.1.1.1 RTA-ospf-1] area 0 RTA-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255 RTB-Serial5/0] fr map ip 192.168.1.1 30 broadcast RTB-Serial5/0] ospf network-tpe p2mp RTB] ospf 1 router-id 2.2.2.2 RTB-ospf-1] area 0 RTB-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255 RTC-Serial5/0] fr map ip 192.168.1.1 40 broadcast RTC-Serial5/0] ospf network-tpe p2mp RTC] ospf 1 router-id 3.3.3.3 RTC-ospf-1] area 0 RTC-ospf-1-area-0.0.0.0] network 192.168. 1.0 0.0.0.255

C. RTA] ospf 1 router-id 1.1.1.1 RTA-ospf-1] peer 192.168.1.2 RTA-ospf-1] peer 192.168.1.3 RTA-ospf-1] area 0 RTA-ospf-1-area- 0.0.0.0] network 192.168.1.0 0.0.0.255 RTB] ospf 1 router-id 2.2.2.2 RTB-ospf-1] area 0 RTB-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255 RTC] ospf 1 router-id 3.3.3.3 RTC-ospf-1] area 0 RTC-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255

D. RTA] ospf 1 router-id 1.1.1.1 RTA-ospf-1] area 0 RTA-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255 RTB] ospf 1 router-id 2.2. 2.2 RTB-ospf-1] area 0 RTB-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255 RTC] ospf 1 router-id 3.3.3.3 RTC-ospf-1] area 0 RTC-ospf- 1-area-0.0.0.0] network 192.168.1.0 0.0.0.255

GB0-381-ENU 문제 88

B As shown in the figure, RTA, RTB, and RTC run OSPF, and the process number is 100; OSPF process 200 runs between RTA, RTB, and RTD. The cost of all interconnected links is set to 10. Set the external route priority of OSPF 100 on RTA and RTB to 190, and import an external route 172.16.1.0/24 into OSPF 100 on RTC. Both RTA and RTB are configured to import OSPF100 routes into OSPF200.
According to the above scenario analysis, the following description about RTD learning external routing 172.16.1.0/24 is correct.

A. There is a route to 172.16.10.0/24 on RTD, and the next hop must point to RTA

B. The route of 172.16.10.0/24 cannot be learned on RTD

C. There is a route to 172.16.10.0/24 on RTD, and the next hop may point to RTA or RTB

D. There are two equal-cost routes to 172.16.10.0/24 on RTD, and the next hop points to RTA and RTB respectively

GB0-381-ENU 문제 89

그림에 표시된 토폴로지에서 RTA 및 RTC에 대해 각각 다음 구성을 수행합니다.
RTA-ospf-1] 영역 1
RTA-ospf-1-area-0.0.0.1] 인증 모드 단순
RTA] 인터페이스 GigabitEthernet0/0
RTA-GigabitEthernet0/0] ospf 인증 모드 단순 일반 12345
RTC-ospf-1] 영역 0
RTC-ospf-1-area-0.0.0.0] 인증 모드 단순
RTC] 인터페이스 GigabitEthernet0/0
RTC-GigabitEthernet0/0] ospf 인증 모드 단순 일반 54321
RTB가 RTA 및 RTC와 각각 이웃 관계를 설정해야 하는 경우 다음 구성 중 RTB에서 수행해야 하는 구성은 무엇입니까?

A. RTB-ospf-1-area-0.0.0.0] 인증 모드 md5 RTB-ospf-1-area-0.0.0.1] 인증 모드 md5 RTB] 인터페이스 GigabitEthernet0/0 RTB-GigabitEthernet0/0] ospf 인증 -mode simple plain 12345 RTB] interface GigabitEthernet0/1 RTB-GigabitEthernet0/1] ospf 인증 모드 단순 일반 54321

B. RTB-ospf-1-area-0.0.0.0] 인증 모드 단순 RTB] 인터페이스 GigabitEthernet0/0 RTB-GigabitEthernet0/0] ospf 인증 모드 단순 일반 12345 RTB] 인터페이스 GigabitEthernet0/1 RTB-GigabitEthernet0/1 ] ospf 인증 모드 단순 일반 54321

C. RTB-ospf-1-area-0.0.0.0] 인증 모드 단순 RTB-ospf-1-area-0.0.0.1] 인증 모드 단순 RTB] 인터페이스 GigabitEthernet0/0 RTB-GigabitEthernet0/0] ospf 인증 -mode simple plain 12345 RTB] interface GigabitEthernet0/1 RTB-GigabitEthernet0/1] ospf 인증 모드 단순 일반 54321

D. RTB-ospf-1-area-0.0.0.0] 인증 모드 단순 RTB-ospf-1-area-0.0.0.1] 인증 모드 단순 RTB] 인터페이스 GigabitEthernet0/0 RTB-GigabitEthernet0/0] ospf 인증 -mode simple plain 54321 RTB] interface GigabitEthernet0/1 RTB-GigabitEthernet0/1] ospf 인증 모드 단순 일반 12345

GB0-381-ENU 문제 90

다음 BGP 속성 중 인식되는 속성은 무엇입니까?

A. Local_Pref

B. 원점

C. 메드

D. AS_PATH

E. 다음_홉

다른 버전: 2251H3C.GB0-381-ENU.v2023-07-05.q259; 1842H3C.GB0-381-ENU.v2022-09-08.q100; 1799H3C.GB0-381-ENU.v2022-04-29.q105

최근 업로드: 128Oracle.1Z0-1126-1.v2025-09-13.q29; 127Oracle.1z0-1042-24.v2025-09-13.q49; 127H3C.GB0-713-ENU.v2025-09-13.q30; 153Juniper.JN0-664.v2025-09-11.q101; 274IAPP.CIPM.v2025-09-11.q242; 134Oracle.1Z0-1160-1.v2025-09-10.q18; 138Oracle.1z0-1054-25.v2025-09-10.q50; 198Cisco.300-710.v2025-09-10.q297; 201VMware.2V0-41.24.v2025-09-10.q104; 266Avaya.78201X.v2025-09-09.q135